Chapter-2| Limit,Fit and Tolrance

A large number of parts of exactly the same dimension cannot be produced commercially. Actual dimension is always little larger or smaller than the desired ones.

The desired dimension of the component is called the nominal dimension.

And the amount of deviation of the actual dimension from the nominal dimension is called the tolerance.

The extreme permissible dimensions of a part are called limits.

Manufacturing tolerance is essential to facilitate the interchangeability of parts that enable proper functioning.

Limit System

A limit system consists of a series of tolerances arranged to suit the specific range of sizes in order to enable specific classes of fit between mating components.

The following are the two bases of limit systems

1. Basic Hole system

In this system, the design size of the hole is the basic size from which allowance is subtracted to obtain the diameter of the shaft.

This system is preferred because standard tooling like drills, reamers, broaches, plug gauges whose size is not adjustable and the shaft can then easily be machined to fit.       

2. Basic shaft system      

In this system, the design system of the shaft is the basic size to which allowance is added to obtain the diameter of the hole.

Fit system

The degree tightness or looseness between mating members is known as the fit of the members.

It depends on the actual value of the individual tolerances of the mating components. The fits can be broadly classified into three categories.

Clearance Fit

It has positive allowance: there is minimum positive clearance between the high limit of the shaft and low limit of the hole. It can be loose or running fit.

Interference Fit

The interference fit is archived by keeping the lower limit of the shaft greater than the upper limit of the hole.

Transition Fit

This fit is one having limits of size so prescribed that the assembly of mating parts can result In either a clearance fit or an interference fit.

This is achieved by keeping the upper limit of the shaft larger than a lower limit of the hole, and the lower limit of the shaft smaller than the upper limit of the hole.

Tolerance system

The tolerances on the dimensions can be specified in three ways:

Unilateral Tolerance System

In this system, the tolerance is provided on only one direction from the basic size  

For example 35.00 plus 0.2,plus 0.5

Bilateral Tolerance system

In this system, the tolerance is split into two parts and shown on both sides of the nominal size.

For example 35.00 plus 0.2,Minus 0.5

Limit Dimension system

In this system, the size and deviation of the part are specified by only maximum and minimum dimensions. For example 35.2 to 35.5 mm

*PLEASE COMMENT IF U HAVE ANY QUERY

Next, Chapter-3| Linear Measurement and Instruments used for Linear Measurement

Back to Home Page

Preview, Chapter-1 | What is Metrology & Measurement?

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: